Stainless-works Ford Taurus SHO Exhaust 2010-14 User Manual download pdf

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183

INSTALLATION INSTRUCTIONS FOR 2010+ TAURUS 3.5L

ECOBOOST CATBACK

Thanks for purchasing a Stainless Works Catback for your 2010+ 3.5L Ecoboost V6. We

have gone to great pains to make sure that our exhaust systems fit and sound great.

Please follow these steps to ensure that your installation goes as planned.

1. Stainless Works recommends the use of Hi-Temp RTV sensor safe silicon gasket

maker as an option to or in conjunction with the use of factory gaskets. The

recommended Oxygen Sensor Safe RTV is either Valco All-in-One Aluminum or

Permatex Copper P/N 101BR available at NAPA, Autozone and other retailers.

2. Disconnect the battery before starting work on the exhaust system for your

vehicle. Reconnect the battery when the job is completed.

3. Your exhaust system can be installed by a weekend warrior but the use of a lift is

recommended for ease of installation. If using a jack, the vehicle must be placed

on a level hard surface and jack stands are required for safety reasons.

4. You will assemble the components together as specified below, but only snug the

clamps as you move along from front to back. When placing the X-pipe into

position, make certain that you push it fully forward and level it in with the

vehicle. After aligning all the components in the vehicle, you will tighten all the

clamps working from front to back of the vehicle.

5. Disconnect Battery.

6. Raise and support vehicle.

7. Remove (4) 10mm nuts from rearmost factory connection point.

8. Remove exhaust from the rubber hangers and remove exhaust.

9. Install X-pipe by assembling to the 2-bolt flanges using (4) 10mm nuts that were

removed earlier from the factory exhaust (seal with RTV silicone).

10. Install 4 x 8 x 14” , 2-in 2-out resonator using (2) 2.5” clamps.

11. Install right and left front tails using dual (welded together) 2.5” clamps.

12. Install 2.5”clamp with wire hanger welded on to the left front tail.

13. Install double 2.5 clamp and right and left rear tail.

1 2 3

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 INSTALLATION INSTRUCTIONS FOR 2010+ TAURUS 3.5L ECOBOOST CATBACK Thanks for purchasing a

Page 2

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 14. Install rear tail hangers. 15. Install mufflers using (2) 2.5” clamps. 16. Install tips u

Page 3

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 SW

No comments

Stainless-works Ford Taurus SHO Exhaust 2010-14 User Manual