Stainless-works Cadillac CTS-V 2009+ Sedan & Wagon Headers User Manual download pdf

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183

INSTALLATION INSTRUCTIONS FOR HEADERS

AND EXHAUST FOR HEADERS FOR 09-14 CADILLAC CTSV

SEDAN, WAGON AND COUPE

Thanks for purchasing Stainless Works Muscleflow Headers for your 09-14 Cadillac

CTSV. We have gone to great pains to make sure that our exhaust systems fit and sound

great. Please follow these steps to ensure that your installation goes as planned.

1. Stainless Works recommends the use of Hi-Temp RTV sensor safe silicon gasket

maker as an option to or in conjunction with the use of factory gaskets. The

recommended Oxygen Sensor Safe RTV is either Valco All-in-One Aluminum or

Permatex Copper P/N 101BR available at NAPA, Autozone and other retailers.

2. Disconnect the battery before starting work on the exhaust system for your

vehicle. Reconnect the battery when the job is completed.

3. Your exhaust system can be installed by a weekend warrior but the use of a lift is

recommended for ease of installation. If using a jack, the vehicle must be placed

on a level hard surface and jack stands are required for safety reasons.

4. You will assemble the components together as specified below, but only snug the

clamps as you move along from front to back. When placing the X-pipe into

position, make certain that you push it fully forward and level it in with the

vehicle. After aligning all the components in the vehicle, you will tighten all the

clamps working from front to back of the vehicle.

DISASSEMBLY

1. Raise and support the vehicle.

2. Disconnect battery.

3. Remove (2) 8mm bolts in cross brace that runs underneath the exhaust. Note that

this cross brace will not be reused during installation of the 3” system.

4. Remove exhaust from factory connection points and rubber hangers and remove.

5. Remove and disconnect (4) O2 sensors.

6. Remove (2) 10mm nuts from right manifold to catalytic converter pipe and

remove.

7. Remove (2) 10mm nuts from left manifold to catalytic converter pipe and remove.

8. Remove covers on Left and Right side of engine compartment.

9. Remove (2) 12mm bolts (2) 12mm nuts holding strut tower brace on and remove.

10. Remove engine covers.

1 2 3

SEDAN, WAGON AND COUPE 1

Summary of Contents

Page 1 - SEDAN, WAGON AND COUPE

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 INSTALLATION INSTRUCTIONS FOR HEADERS AND EXHAUST FOR HEADERS FOR 09-14 CADILLAC CTSV SE

Page 2

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 11. Remove air box and air inlet. 12. Remove spark plug wires from coil packs. 13. Remove dip

Page 3

WWW.STAINLESSWORKS.NET 800-878-3635 FAX: 440-543-9183 FINAL ASSEMBLY FOR STAINLESS WORKS HEADERS 1. Re-install O2 sensors a

Comments to this Manuals

No comments

Stainless-works Cadillac CTS-V 2009+ Sedan & Wagon Headers User Manual

Browse online or download User Manual for For the car Stainless-works Cadillac CTS-V 2009+ Sedan & Wagon Headers. Stainless Works Cadillac CTS-V 2009+ Sedan & Wagon Headers User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Stainless-works Cadillac CTS-V 2009+ Sedan & Wagon Headers